30
edits
Changes
Jump to navigation
Jump to search
Line 3:
Line 3: − + − + Line 43:
Line 43: − + + − +
→Pre-Flight Checklist
== Software ==
== Software ==
The software repo is here. The board is programmed using Platform IO in VS code.
The software repo is [https://github.com/LSkaling/Flying-Phoque-6.0/tree/main here]. The board is programmed using Platform IO in VS code.
== Setup ==
== Setup ==
Setup instructions assume board is just being used for data logging (TODO: add instructions to use as flight computer)
Setup instructions assume board is just being used for data logging (TODO: add instructions to use as flight computer)
# Ensure the board is not contact any metal surfaces
# Ensure the board is not contacting any metal surfaces
# Check that the internal power header pins aren't connected (see photo)
# Check that the internal power header pins aren't connected (see photo)
# Insert SD card into Teensy
# Insert SD card into Teensy
* Battery fully charged (around 8.4v)
* Battery fully charged (around 8.4v)
* SD card has sufficient capacity (Data logs generate about 10 megabytes per hour)
* SD card has sufficient capacity (Data logs generate about 10 megabytes per hour)
* SD installed into the slot and retained with tape
* SD installed into the slot
* Internal power jumper installed (top right)
* Internal power jumper installed (top right)
* Board powered on, displays green LED and correct chips, and then powered off again
* Board powered on, displays green LED and correct chips, and then powered off again
* SD card checked to verify data is being logged properly. Re-inserted into SD card slot, and retained with electrical tape.
Pre-launch:
Pre-launch:
# Arm the switch
# Arm the switch
# Correct beeping pattern (slow chirps spaced a few seconds apart)
# Correct beeping pattern (slow chirps spaced a few seconds apart, with a green LED)
#
#