VB Gen 8.1 Avionics

Revision as of 02:45, 10 September 2017 by Ariatedjarati (talk | contribs)
ValBal Generation 8.1 Avionics
Part of the ValBal series
Vb811 1.JPG
Chief Designer Aria Tedjarati
Technology Line Balloons ValBal Architecture
Version Generation 8.1
Name ValBaby

The ValBal Gen 8.1 Avionics is the eighth generation and twelfth iteration of of the ValBal core electrical architecture. It is the most up-to-date and highest performing ValBal avionics version as of September 2017, consisting of two 3-inch by 3-inch FR4 PCB's that are stacked on top of one another above 33 AA non-rechargeable lithium primary batteries. The architecture makes significant changes and improvements on the ValBal Generation 8.0 architecture, including changes in physical size, stacking connectors, power regulation and efficiency, cost, wireless communication, and more.

The details of the ValBal generation 8.1 avionics are outlined below in exhaustive detail.

Introduction

ValBal is an actively altitude-controlled, low-cost, high-endurance, autonomous latex high altitude balloon system. It requires a complex set of avionics hardware to enable it to complete its mission. In general, at a bare minimum, any ValBal avionics system must have the following set of features to ensure a successful flight.

  • Half-duplex or full-duplex wireless communication
  • Dual bidirectional high power motor control
  • High altitude GPS location acquisition capability
  • Power regulation and subsystem protection
  • Temperature regulation
  • Barometric pressure & temperature sensing, filtering, and error detection
  • Powerful microprocessor with autonomous flight code
  • Current & voltage sensing of all system parameters
  • Weigh no more than approximately 1 kilogram
  • Have a form factor of less than 3 x 3 x 6 inches

The 8.1 generation of ValBal avionics goes above and beyond these minimum requirements.

Mainboard

Microcontroller

Radio Board