3D Printer: Difference between revisions

Latest revision as of 02:17, 14 February 2022

Using the 3D Printer

If you do not know how to use a 3D printer, do not use the printers without asking for help! Message the #3dprinters Slack channel and someone can train you.

SSI uses Prusa i3 MK3S printers. The preferred slicing software is PrusaSlicer, which can be downloaded here.

Printer etiquette

If switching filament thread the loose end of the filament through the holes in the spool so that it doesn't become tangled
If a printer is having issues leave a note on the printer explaining the issue and alert the #3dprinters channel
Clean up any failed prints
Any hygroscopic filaments such as Nylon and TPU should be stored in the low-humidity PolyBox to keep them in good condition

3D Printer Troubleshooting Guide

Make sure to clean the bed with rubbing alcohol before each print to improve bed adhesion
Double check your slicer settings are set for the type of filament you are using

@@ Line 5: / Line 5: @@
+'''If you do not know how to use a 3D printer, do not use the printers without asking for help!''' Message the #3dprinters Slack channel and someone can train you.
+SSI uses Prusa i3 MK3S printers. The preferred slicing software is PrusaSlicer, which can be downloaded [https://www.prusa3d.com/page/prusaslicer_424/ here].
+=== Printer etiquette ===
+* If switching filament thread the loose end of the filament through the holes in the spool so that it doesn't become tangled
+* If a printer is having issues leave a note on the printer explaining the issue and alert the #3dprinters channel
+* Clean up any failed prints
+* Any hygroscopic filaments such as Nylon and TPU should be stored in the low-humidity PolyBox to keep them in good condition
 == 3D Printer Troubleshooting Guide ==
+* Make sure to clean the bed with rubbing alcohol before each print to improve bed adhesion
+* Double check your slicer settings are set for the type of filament you are using