Difference between revisions of "3D Printer"
(Created page with " == Using the 3D Printer == == 3D Printer Troubleshooting Guide ==") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
| + | '''If you do not know how to use a 3D printer, do not use the printers without asking for help!''' Message the #3dprinters Slack channel and someone can train you. | ||
| + | SSI uses Prusa i3 MK3S printers. The preferred slicing software is PrusaSlicer, which can be downloaded [https://www.prusa3d.com/page/prusaslicer_424/ here]. | ||
| + | |||
| + | === Printer etiquette === | ||
| + | |||
| + | * If switching filament thread the loose end of the filament through the holes in the spool so that it doesn't become tangled | ||
| + | * If a printer is having issues leave a note on the printer explaining the issue and alert the #3dprinters channel | ||
| + | * Clean up any failed prints | ||
| + | * Any hygroscopic filaments such as Nylon and TPU should be stored in the low-humidity PolyBox to keep them in good condition | ||
== 3D Printer Troubleshooting Guide == | == 3D Printer Troubleshooting Guide == | ||
| + | |||
| + | * Make sure to clean the bed with rubbing alcohol before each print to improve bed adhesion | ||
| + | * Double check your slicer settings are set for the type of filament you are using | ||
Latest revision as of 02:17, 14 February 2022
Using the 3D Printer
If you do not know how to use a 3D printer, do not use the printers without asking for help! Message the #3dprinters Slack channel and someone can train you.
SSI uses Prusa i3 MK3S printers. The preferred slicing software is PrusaSlicer, which can be downloaded here.
Printer etiquette
- If switching filament thread the loose end of the filament through the holes in the spool so that it doesn't become tangled
- If a printer is having issues leave a note on the printer explaining the issue and alert the #3dprinters channel
- Clean up any failed prints
- Any hygroscopic filaments such as Nylon and TPU should be stored in the low-humidity PolyBox to keep them in good condition
3D Printer Troubleshooting Guide
- Make sure to clean the bed with rubbing alcohol before each print to improve bed adhesion
- Double check your slicer settings are set for the type of filament you are using