51
edits
Changes
no edit summary
== PCB Layout ==
== PCB Layout ==
Gen 5 Avionics remains a 4-layer board, compliant with Gen 2 Architecture. All signals were routed on the top and bottom layers, while only the heater trace went beyond those two layers. While it may be possible to route the heater trace on the top and bottom layer, it will be much more difficult, if impossible, to apply the traces directly to the components which require heat, such as the GPS and MCU.
Gen 5 Avionics remains a 4-layer board, compliant with Gen 2 Architecture. All signals were routed on the top and bottom layers, while only the heater trace went beyond those two layers. While it may be possible to route the heater trace on the top and bottom layer, it will be much more difficult, if impossible, to apply the traces directly to the components which require heat, such as the GPS and MCU.
== Schematics ==
<gallery widths=200px heights=200px>
File:g5_top.PNG | <center> Top Sheet </center>
File:bypasscaps.PNG | <center> Bypass Capacitors </center>
File:can.PNG | <center> CAN </center>
File:gps.PNG | <center> GPS </center>
File:GFSK.PNG | <center> Radio </center>
File:cutdown.PNG | <center> Cutdown </center>
File:g5_micro_sd.PNG | <center> SD Card </center>
File:g5_thermocouple.PNG | <center> External Temperature Sensing </center>
File:g5_multiplexer.PNG | <center> Multiplexer for LEDS </center>
File:leds.PNG | <center> Status LEDs </center>
File:g5_rb_connector.PNG | <center> RockBlock Connector </center>
File:g5_stackbus.PNG | <center> Connections to Stackbus </center>
File:g5_teensycore.PNG | <center> Teensy 3.6 </center>
File:g5_pressure_sensors.PNG | <center> Pressure Sensors/center>
</gallery>