700
edits
Changes
Jump to navigation
Jump to search
Line 28:
Line 28: − The particular payload breakout itself is a 1.27mm pitch 2x25 pin keyed, shrouded connector. This decision was made to make the breakout as small as possible, and keep the cabling thin. The exact connector, and associated cabling, are:+ − − Connector: Samtec SHF-125-01-L-D-RA − Cabling: Samtec FFSD-25-D-XX.XX-01-N − − In the above, XX.XX denotes the length -- which can be custom as desired, in inches (2 inch minimum). − − The specific pin out for ''Venom Breakout'' is the following, with the first row as the top, second row as the bottom, left to right as seen looking into the receptacle from the board-edge. − − {| class="wikitable" − |- − |5V − |3.3V BUS − |VBATT (4.2V) − |12V − |1.8V − |SDA − |SCL − |MOSI − |MISO − |SCLK − |VA_PWM − |CHIRP − |R_MCU − |R_ALL − |S_READY − |LOW_PWR − |FMODE − |SYS_F3 − |SYS_F4 − |SYS_F5 − |SYS_F6 − |(+5 S) − |(-5 S) − |CAN_SPD − |GND − |- − |5V − |3.3V BUS − |VBATT (4.2V) − |12V − |VADJ OUT − |TX4 − |RX4 − |TX6 − |RX6 − |DAC0 − |DAC1 − |AV29 − |AV42 − |AV17 − |AV16 − |AV35 − |AV36 − |AV37 − |AV38 − |CAN1_H − |CAN1_L − |(+12 S) − |(-12 S) − |3.3V CAN − |GND − |}
no edit summary
There is no need for more than two payload breakouts, with the expectation that all boards that receive the payload breakout also have a secondary connector to allow for continued daisy chaining. This is the case, for example, on ProtoBee.
There is no need for more than two payload breakouts, with the expectation that all boards that receive the payload breakout also have a secondary connector to allow for continued daisy chaining. This is the case, for example, on ProtoBee.
Details of the Venom Breakout can be found on the [Venom_Breakout | Venom Breakout] page.
=== Master Breakout ===
=== Master Breakout ===