SSI Hall of Coaster-makers
|
Category
|
Error
|
Description
|
Solution
|
Notable Entrant
|
Schematic Errors
|
Inconsistent Net Naming
|
When two nodes must be electrically connected but aren't visually connected in the schematic by a single wire, naming their nets two different things and causing there to be no connection, leading to a trace not being placed.
|
Check ICs to make sure all pins are routed or appropriately not connected.
|
Sasha Maldonado, on ValBal Generation IV, where the chip select for an SD card was labeled "SDCS" at one point and "CS" at another.
|
Wires and Pins Not Aligned On Grid
|
Improperly setting the snap grid in the schematic editor, such that wires and pins can appear connected at a quick glance but not actually be connected, leading to a trace not being placed.
|
Check ICs to make sure all pins are routed or appropriately not connected. Avoid setting the schematic editor snap grid to anything other than 10 [units].
|
Kirill Safin, on HAB Main Avionics PoS1, where a number of pins appeared connected but were very much not.
|
Silkscreen Errors
|
Silkscreen Over Pads/Vias
|
When silkscreen - a line, part label, etc - is place over an etched pad or a via and therefore doesn't fully print.
|
Visualize the board in 3D 3 , where intersections between silkscreen and board features are more obvious.
|
Sasha Maldonado, on ValBal Generation V, where multiple part labels were printed over exposed copper and so were awkwardly clipped - some to the point of being nonfunctional.
|
Failure to Place Information on Board
|
Not placing the standard set of silkscreen features on a board - board name, designer name(s), date, revision, sponsor logos, SSI logo. "Made with <3 in Stanford, CA" is hardly required but encouraged.
|
Just do it. Seriously. Your work takes a bunch of your time. It should look good.
|
Cameron Ramos, who did none of this on the Can Transceiver Board v2.
|