77
edits
Changes
Jump to navigation
Jump to search
Line 18:
Line 18: − + + − + + + + + + + + + + +
no edit summary
'''NOTE:''' Completely assemble the structural components of the of the AV bay, with the mounting rack, bulkheads, and coupler put clamped together, and all of the holes on the bulkheads lined up ''before'' epoxying anything, to make sure that every piece is oreiented correctly, then disassemble and epoxy. This is easier than you might think to mess up.
'''NOTE:''' Completely assemble the structural components of the of the AV bay, with the mounting rack, bulkheads, and coupler put clamped together, and all of the holes on the bulkheads lined up ''before'' epoxying anything, to make sure that every piece is oreiented correctly, then disassemble and epoxy. This is easier than you might think to mess up.
===All threads===
===Couple and All threads===
=Mounting Avionics=
===Coupler===
'''NOTE:''' The specific electronics used in an AV bay often differ, so there is no single best way to mount everything. Before drilling holes or permanently attaching anything, lay out all of the components and make sure that you have enough room. '''Remember that there are all threads running on each side of the mounting rack, so make sure there is space for them when mounting electronics.''' Also, remember that wires are actually a thing, so plan space for them. Think about how you will close up the AV bay with wires attached to the top and bottom bulk head. ''Think everything through before mounting stuff.''
===Altimeter===
While each type of Altemeter are mounted slightly differently, they should all be mounted with screws and spaces, or standoffs. Place the altimeter on the mounting rack where it will be mounted, and mark where the
===Batteries===
===Pin Switch===