17
edits
Changes
Jump to navigation
Jump to search
Line 51:
Line 51: − + +
Avionics Onboarding 2020 (view source)
Revision as of 03:40, 11 December 2020
, 03:40, 11 December 2020→Module 0: Safety
* When working with LEDs, make sure to add a resistor to avoid frying the LEDs.
* When working with LEDs, make sure to add a resistor to avoid frying the LEDs.
* When working with the Feather, make sure to ''' never connect any of the ground pins to the 3.3 V pins '''. This could damage the board, and we may be unable to replace the board.
* When working with the Feather, make sure to ''' never connect any of the ground pins to the 3.3 V pins '''. This could damage the board, and we may be unable to replace the board.
* '''Disconnect the Feather from its battery and micro USB connection when rewiring anything on the breadboard.''' This makes it less likely to accidentally connect the GND and 3.3 V pins and cause a short, which could damage your board.
* '''Disconnect the Feather from its battery and micro USB connection when rewiring anything on the breadboard.''' This makes it less likely to accidentally connect the GND and 3.3 V pins and cause a short, which could damage your board.
* '''Always double check your connections before connecting the Feather to a micro USB cable or to the Feather battery. '''
== Module 1: Intro ==
== Module 1: Intro ==