Fang Breakout

Revision as of 20:43, 18 August 2017 by Ksafin (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Fang Breakout
Part of the HONEY Architecture series
& the HABEES series
Chief Designer Kirill Safin
Technology Line Balloons Core Architecture
Version Generation I
Name Fang Breakout
General
HONEY Standards Venom Breakout Fang Breakout Board Naming
Core Software
STINGR
Core Avionics
The Count
Core Power
Biscuit
Core Peripherals
Cobra Viper ProtoBee
Core Radio
Macaw
Test & Prototype
QueenBee
Guides
Making a HONEY Board Using STINGR Using QueenBee Making a Prototype
VE

The Fang Breakout is the secondary variety of breakout for the HONEY flight stack. It was introduced in the development of the HONEY Gen 1 Breakout, Viper. As of time of writing (Aug 10, 2017), it has no impending implementation scheme. It exists in the first revision of the HAB Breakout to facilitate two things -- one, the possible eventual need to break out the additional remaining pins, and, more importantly, two -- to enable directly using female jumper wires to tap signals directly from Viper, by providing a standard-pitch connector that can be both directly tapped or cabled.

The connector and associated cabling are: Connector: Samtec TST-156-01-F-D-RA Cabling: HCSD-28-D-XX.XX-01-S-N-G

The Fang Breakout pinout is very similar to the Venom Breakout, with some slight alterations:

5V 3.3V BUS VBATT (4.2V) 12V 1.8V SDA SCL MOSI MISO SCLK VA_PWM CHIRP R_MCU R_ALL S_READY LOW_PWR FMODE SYS_F3 SYS_F4 SYS_F5 SYS_F6
5V 3.3V BUS VBATT (4.2V) 12V VADJ OUT TX4 RX4 TX6 RX6 DAC0 DAC1 AV29 AV42 AV17 AV16 AV35 AV36 AV37 AV38 AVA10 AV51


Continued, from the right of the top table:

CAN2_H CAN2_L (+5 S) (-5 S) (+12 S) (-12 S) GND
AV52 AV53 CAN1_H CAN1_L CAN_SPD 3.3V CAN GND