Difference between revisions of "SSI-24"

From Stanford SSI Wiki
Jump to navigation Jump to search
Line 6: Line 6:
 
| launch coordinates = 36.84842,-121.43236
 
| launch coordinates = 36.84842,-121.43236
 
| top speed = 92.44 MPH
 
| top speed = 92.44 MPH
 +
| ground track = 121.21 miles
 
| last = 23
 
| last = 23
 
| next = 25
 
| next = 25

Revision as of 18:32, 27 October 2015

SSI-24 (Orion)
Ssi 24.png
Launch date October 24th, 2015, 11:39AM PDT
Launch site 2093 San Juan Drive, Hollister, CA
Launch coordinates 36.84842,-121.43236
←SSI-23 SSI Balloon Launches SSI-25→


SSI-24 Orion was one of three balloons launched during fall quarter, 2015. It consisted of an almost all-freshman team dedicated to creating a scientifically power yet aesthetically beautiful payload. Ultimately, Orion represented a resounding success in its use of sensors, logging of data, power management, use of solar energy to charge its batteries, demonstration of wifi transmissions, and creation of a visually refined payload.

Pre-Launch

The Pre-Launch proceeded fairly well with few hiccups. After fixing minor problems with the solar panel wiring, the team prepared the gimbal and finished visual preparation of the payload. Unfortunately, the team experienced extreme difficulties setting up the keychain camera (which did not function during flight). The payload, which consisted of two styrofoam boxes and a selfie stick, was attached to a single 1500g balloon.

Flight

SSI-24 used the SPOT Nebula for tracking and recovery. See http://habmc.stanfordssi.org/#/app/spot_four. A Phantom 2 UAV was used by members of Orion to video the launch of SSI-23a, 23, 24, and 25.


Phantom 2

Experimental Payload

Perspective view of the Orion sensor payload.

SSI-24 included both a Raspberry Pi 2B and two Arduino Uno boards. The Raspberry Pi was initially intended to be used to stream live video from the balloon, however, due to issues with the camera board, it was simply used as a wifi access point. The two Arduino boards regulated the sensors onboard the balloon, including a temperature sensor, two heating pads, an SD reader, a GPS, a solar panel, and an accelerometer. Though the group initially intended to use a PIXY camera as well, the PIXY's requirement to be updated with signatures made it difficult to use aboard the balloon.

The second board served a single purpose: dropping three Hershey's chocolate bars at a specified altitude. This was accomplished using the GPS altitude from the first Arduino, which would set a single digital pin to high. This would trigger the second Arduino to swing a servo and release the bars.

Wifi Antenna

Milestones

  • First use of wifi antennas and Raspberry Pi on an SSI high altitude balloon
  • Successful implementation of a gimbal for the SPOT GPS
Balloon Launches
2014-15 SSI-19202122
2015-16 SSI-23(a) • 2425262728293031323334353637383940414243
2016-17 444546474849505152
2017-18
2018-19 8386879091
2019-20 929397
VE